Polymer Clay Cutters – Organic 3 Layer Earring Clay Cutter

$11.90$29.90

or 4 fortnightly payments Afterpay More info

Product Description

Polymer Clay Cutters for Earrings | Organic 3 Layer Earring Cutter Set | DIY Craft tools | DIY Jewelry

Polymer Clay Cutters for Earrings – Organic 3 Layer

—– PLEASE READ FULL DESCRIPTION BEFORE PURCHASING —–
– All 9 cutters from the full set can be mixed to create so many variations for Polymer Clay earrings.
– Possibilities are endless, so explore and have fun with it.
– You can use the small stud top cutters to create 3 or 4 layer dangle earrings (or) you can only use the stud top and the lower large dangle cutters to create 2 layer dangle earrings.
– The cutting edge is less than 1 mm thick to get a clean so that the after cleanup is to a minimal. It is expected that a small amount of sanding of your polymer clay piece is required after using these cutters.

To View Similar Clay Cutters → Click Here

To View Pattern texturing tools for clay → Click Here

RECOMMENDATIONS:

– A stiffer clay would be easier to work with while cutting out the clay with 3D printed cutters to get a firm cutout edge.
– If you are living in a hot and humid climatic condition, then sometimes your clay can be sticky. To avoid your clay getting stuck inside the cutters, place a piece of cling wrap on top of your roller out clay and then use the cutters to cut out the shapes. Or you could also work your clay with cornflour or polymer clay powder before pressing the cutters into the clay
– Apply pressure onto the cutters to press down the clay to cut all the way through. Do not apply sideways pressure as this would distort the clay shape.
– Then once you remove the clay from your working surface make sure to smooth the edges of the clay with your fingers before baking the clay so that you will spend less time sanding the edges if at all you want to sand the edges.

CARE INSTRUCTIONS:

– Hand wash in normal or light warm water.
– Before washing, You can use a sharp object to remove clay stuck in the cutters into any intricate corners or gaps
– Do not expose or store the cutters to high temperature

Hope you have fun getting creative.

If you need more information or need customisation regarding the cutters please contact us by Clicking Here