Snowflake Cutter (7cm Dia) – Christmas Cutters

Snowflake Cutter (7cm Dia) – Christmas Cutters

– The cutting edge of the Snowflake Polymer clay cutters is less than 1 mm thick to get a clean cut so that the after cleanup is to a minimum. It is expected that a small amount of sanding of your polymer clay piece is required after using these cutters. We do not guarantee a perfect cut, but it will be a relatively clean cut.

CUTTER HEIGHT SELECTION

– Usually, clay earrings are made at 3mm to 4mm thickness so 10mm deep cutters are sufficient for cutting the clay, But if you think you need more grip on your hands to hold the cutters then go for 15mm tall cutters.
– If you need the Arch Shaped Clay Cutters deeper please contact me and I can make the cutters to your requirement.

RECOMMENDATIONS:

– A stiffer clay would be easier to work with while cutting out the clay with 3D printed cutters to get a firm cutout edge.
– If you are living in a hot and humid climatic condition, then sometimes your clay can sticky. To avoid your clay getting stuck inside the cutters, place a piece of cling wrap on top of your roller out clay and then use the cutters to cut out the shapes. Or you could also work your clay with corn flour or polymer clay powder before pressing the cutters into the clay
– Apply pressure firmly and evenly on to the cutters to press down the clay to cut all the way through. Don’t apply sideways pressure as this would distort the clay shape.
– Make sure to trim the edges if there is any excess before backing so that you spend less time sanding the pieces.

CARE INSTRUCTIONS:

– The material of the Cutter and Texture roller is PLA Eco Plastic so keep away from heat temperature higher than 70 °C
– Wash before first-time use.
– Hand washes only.